— US-7 —
COOLING FINS CLEANING
1. Loosen the knob and lift off the cylinder cover.
2. Clean all dirt and debris from the cooling fins and from around the
cylinder base.
3. Reinstall the cylinder cover.
FUEL FILTER
The fuel filter is attached to the end of the fuel pick_up hose inside the
fuel tank. After each 25 hours of use, it should be checked for dirt or
damage, and replaced if necessary. Using a wire hook, gently pull the
fuel filter out through the fuel filler opening. Grasp the fuel hose next to
the fuel filter fitting and remove the filter, but do not release the hose.
While still holding on to fuel hose, attach the new fuel filter. Drop the
new fuel filter back into the fuel tank. Make sure that the fuel filter is not
stuck in a corner of the tank, and that the fuel hose is not doubled over
(kinked) before refueling.
LUBRICATION : GEARCASE
The gearcase should be checked for lubrication after each 30 hours of
use. Remove the cutting attachment and the boss adapter. Clean any
dirt and debris from the area between the boss adapter and the
gearcase. Remove the grease plug from the side of the gearcase.
While rotating the attaching shaft, Inject lithium base bearing lube (P/N
211337) through the plug hole until the gearcase is full. Reinstall the
boss adapter and grease plug.
GENERAL CLEANING AND TIGHTENING
The FUREKY brushcutter will provide maximum performance for many,
many hours if it is maintained properly. Good maintenance includes
regular checking of all fasteners for correct tightness, and cleaning the
entire machine.
STORAGE
For long term storage of the Brushcutter, perform all regular maintenance procedures and needed repairs.
Empty the fuel tank. Start the engine and allow it to run until it stops. Pull the starter cord a few times to
remove any excess fuel from the engine. Remove the spark plug and insert a small amount of oil. Pull the
starter cord once and bring the piston to a position closest to the spark plug hole. Reinstall the spark plug.
Store the brushcutter in a dry place away from excessive heat, sparks or open flame.
Bearing Lube
(P/N.211337)
Grease Plug
Plug Hole
Gearcase
Attaching Shaft
Boss Adapter
Wire
Fuel Pick-up Hose
Fuel Filter
Cylinder Cover
Knob
Cooling Fins