34 Canyon View Drive Orinda, CA., 94563 p:925.253.2969 f:925.253.4894
USING THE SYNTH300 GUI UNDER WINDOWS
The Synth300 GUI has four sections. The upper right section controls the settings for Synthesizer A.
The lower right section controls the settings for Synthesizer B. The upper left hand window shows the
configuration that has most recently been written to the selected synthesizer board initiating the current
settings and resulting outputs. The lower left hand portion allows selection of the Synth300 board to
write to (if multiple boards are installed in the system) as well as check boxes for external clock and
external modulation choices.
For a given use, the user simply enters the desired frequencies and phases for each synthesizer, (and
frequency sweeping and/or external modulation if desired) and then clicks on “Configure Board”.
It is
important to note that no change will occur until the user clicks on the “Configure Board”
button (or hits “return”).
r1v06
Page 14 of 31
Copyright © 2008 – 2010 Furaxa Inc.