Funtek FTK-MT12-NEO/GR, User Manual

Page: 3 / 22

- 3 -
ENGLISH
FRAN
Ç
AIS
CHARGE AND INSTALL RECHARGEABLE BATTERY PACK
CHARGER / BATTERY PACK / CIRCUIT BOARD PRECAUTIONS
1. Connect the lithium-iron battery pack to the charger
(Figure 1), note the charge light turns green.
Insert the charger into the outlet (Figure 2), note the charger
Iight turns red - indicating it’s charging.
When charging is completed, charger light turns green again.
1. To prevent the lithium-ion battery pack from being charged over
-voltage, which could lead to damage or explosion, the charger uses
a voltage limit protection device. And to maintain the battery pack’s
charging capacity and performance, we suggest not to charge it
continuously for more than 24 hours.
2. The battery uses a low voltage and power over-discharge protection
device. When the battery is over-discharged, a re-charged is required to
active the battery again. It is recommended that you remove the battery
and turn the switch to OFF position when the car is not being used.
3. The circuit board uses a overheating protection function. When the circuit board is overheated, the car will be disabled (not moving forward/
backward) for 3-6 seconds before being restored.
3. Connect the sockets of the rechargeable battery packand
the car in correct polarities, then insert the batteryinto the
battery compartment. (Figure 4)
2. Loosen the latches of the battery cover on the bottom of the
car, then removethe battery cover. (Figure 3)
4. Close and secure the battery coverby tightening the latches.
(Figure 5)
Figure 1
Figure 3
Figure 5
Power Light Power Switch (Figure 4)
Figure 2