First-time Setup
3.6
Connecting an External Alarm
NOTE:
A large portion of the installation of an alarm will vary based on the type
of alarm. Because of this, the following instructions are not comprehensive, and
will have to be supplemented by specific instructions for your desired external
alarms/systems. Please refer to our knowledge base (
http://kb.zmodo.com/
) for
more information.
Prior to installation, please locate the alarm input and output ports on the back
panel of your NVR. The following instructions will show you how to plug in the
wires from the external system to the NVR.
1. Push the orange tab on the alarm port (with your finger nail or pen) in order to
open the spring-loaded connection.
2. With the orange tab pushed in, insert the bare wire from your alarm about 1/8-
1/4 inches into the port.
3. Let go of the orange tab and the port should clamp onto the cable. Give the
wire a light tug to ensure that it is securely clamped.
3.2
Camera Installation
Connecting the cameras to the NVR
1. Remove the cameras from the packaging and set it near the NVR.
2. Connect all four cameras to the NVR using the provided PoE cables by
plugging one end to the Ethernet port of the cameras and one end to the port on
the back of the NVR.
Summary of Contents for ZP-IBT15-S
Page 1: ...1...
Page 2: ...2...
Page 14: ...Product Introduction 2 7 Front Panel Rear Panel...
Page 15: ...Product Introduction 2 8 Mouse...
