TRT800A / P/N 800ATC-A-(201)-(301)
Operation and Installation
22
Document-No: 03.2112.010.71e / Revision: 1.02
3.9 Post-Installation
Check
All steering and control functions of the aircraft are to be examined, in
order to exclude disturbances by the wiring.
The most important factor in the transponder configuration is the setting
of the ICAO address (see section 4.2.1).
3.10 Starting
Up
Turn the transponder on with
.
After start-up the following screens appear:
Attenuation from antenna to transponder at 1090 MHz must
not exceed 1.5 dB!
A certified maintenance shop must verify proper operation of
the transponder by testing in accordance with
Appendix F of
“14 CFR Part 43 – ATC Transponder Tests and
Inspections”.
The TRT800A starts in Standby Mode (indicated with
STBY). In order to change into operational mode (indicated
with ACS) press
.
Very important is the correct configuration of the 24bit
Aircraft-Address (see 4.2.1 Setup Steps).
