Page 10
XO1 Operators Manual
Operating the XO1
Preliminary Set-up
The procedure below should be followed when first installing a XO1.
Design your crossover! To do this, press MENU, and use the BACK or NEXT key to
select ‘X-over sub-menu’ and then press ENTER. Use the BACK or NEXT key to
select ‘Design a X-over’ and then press ENTER. Finally, use the BACK or NEXT key
to select the desired configuration and follow the set-up wizard to finalise your
design.
Note that when in a menu, ENTER is always used to confirm selections. The current
selection is marked with an asterisk ‘*’.
Use the SELECT keys on each output channel with the BACK and NEXT keys to
select the high pass filters, low pass filters, parametrics etc. Note that when
designing a new crossover, the high and low pass filters will be set to default values.
See appendix 2 for more information.
Use the SELECT keys on each input channel with the BACK and NEXT keys to select
the gain, delay and parametrics available on each input.
Note that if no action is taken in menu mode, the unit will return to normal
‘default’ mode after about twenty (20) seconds. Repeat the above
directions to return to menu mode.
