FUNAI TVD-A2104PT, Service Manual

Page: 17 / 113

1-6-2 T6100DC
Reference Notes in the Table
Caution !
When removing the CRT, be sure to discharge the
Anode Lead of the CRT with the CRT Ground Wire
before removing the Anode Cap.
Reference Notes in the Table
CAUTION 1: Discharge the Anode Lead of the CRT
with the CRT Ground Wire before removing the Anode
Cap.
1. Disconnect the following: Anode Cap, CN501A,
CRT CBA, CL501A, CN151, CN301, CN571,
CN601, and CN1801.
Then remove Tray Chassis Unit.
CAUTION 2: Electrostatic breakdown of the laser
diode in the optical system block may occur as a
potential difference caused by electrostatic charge
accumulated on cloth, human body etc., during
unpacking or repair work.
To avoid damage of pickup follow next procedures.
2-1. Remove two screws (S-7) and remove Loader
Cover.
2-2. Disconnect Connector (CN301) on the DVD Main
CBA Unit.
2-3. Short the three short lands of FPC cable with sol-
der before removing the FFC cable (CN201) from
it. If you disconnect the FFC cable (CN201), the
laser diode of pickup will be destroyed. (Fig. 4)
2-4. Remove four screws (S-8) and remove DVD Main
CBA Unit.
CAUTION 3: When reassembling, confirm the FFC
cable (CN201) is connected completely. Then remove
the solder from the three short lands of FPC cable.
(Fig. 4)
4. Remove screws 6(S-10) and (S-11), and remove
Top Cover. Remove screw (S-12) and remove Bot-
tom Plate. Remove screws (S-13), (S-14) and 7(S-
15). Disconnect Connector (CN201). Then, desol-
der connectors (CL401, CL402, CL403) and lift up
the Deck Assembly.
Fig. 1
[1] Rear Cabinet
(S-1)
(S-1)
(S-3)
(S-3)
(S-1)
(S-1)
(S-2)
(S-1)
(S-1)