7
Manual
FUMEX FBE
1100
4 Preparation for use
Fig. 3
Never work or stand underneath suspended
loads!
When lifting and/or replacing parts, it is
important that the lifting device is stable and
secured. Only use suitable and technically
sound lifting gear and load-bearing equip-
ment with sufficient capacity.
4.1 Transport & storage
Protect the machine and its parts from rain,
snow, aggressive atmospheres and other
harmful effects.
4.2 Electrical equipment
The equipment is fed with high voltage and
must always be equipped with a safety
switch for service work in connection with
the fan.
To meet the applicable standards, the fan
must always be equipped with a protective
motor switch, and overcurrent protection
(not applicable when feeding from frequency
converters).
If control devices (e.g. frequency converters)
are used, the manufacturer’s recommenda-
tions to avoid interference are followed. For
example, EMC, protective earth, cable-length
cable shielding, etc.
The choice of cable and cable area must comply with
the national requirements applicable to fixed installa-
tions. For electrical installation, see Section
10.2 Circuit
diagram electronics
.
4.3 Assembly & installation
National rules and regulations must always be adhered
to during assembly work.
4.3.1 Unpacking
1.
Carefully unpack the product.
2.
Check for any damage and missing parts. Contact a
local Fumex representative directly if there is dama-
ge or parts are missing.
3.
Dispose of the packaging material according to local
recycling regulations.
4.3.2 Moving the machine
When moving, use the lifting eyes desig-
ned for lifting with a round loop rated for 1
tonne, so as not to damage powder coated
surfaces. See
Fig. 3
.
Summary of Contents for FBE 1100 LG 0
Page 1: ...FBE 1100 Manual ...
Page 17: ...17 Manual FUMEX FBE 1100 12 Notes ...
Page 18: ...18 Manual FUMEX FBE 1100 ...
Page 19: ...19 Manual FUMEX FBE 1100 ...