Full Vision TRACK MASTER TMX428, Owner'S Manual

Page: 79 / 83

317-160-284 Rev 6
TMX428 Owner’s Manual
77
February 2021
Reprocessing Instructions
The following reprocessing instructions apply to all treadmills. The treadmill is neither sterile nor can it be sterilized.
Manufacturer: Full Vision Inc Symbol:
Device(s): Treadmills
WARNINGS
Before cleaning the device, turn the main power switch to OFF and
disconnect the treadmill from its power outlet.
Never use wet cleaning materials near a power source: you could suffer an
electrical shock.
Do not improperly clean the device

During cleaning, do not allow fluid to enter the motor pan assembly
area.

Always wear appropriate PPE when cleaning.

Do not use abrasive brushes or abrasive cleaners. This could
damage the paint and plastic surfaces.

Do not use sharp tools (e.g. knife, metal scraper) or aggressive
cleaning solvents for cleaning

Alcohols are flammable and should only be used in well ventilated
spaces

DO NOT use disinfection with a phenol base or peroxide
compound to disinfect the external surface
Limitations on
Processing Not Applicable
INSTRUCTIONS
Initial Treatment at
the Point of Use Use a soft, clean, lint-free cloth / paper towel dampened (not wet) with tap
water and mild detergent to wipe all treadmill surfaces to remove excess
soil, moisture, and perspiration.
Preparation Before
Cleaning All cleaning solutions should be prepared at the dilution and temperature
recommended by the manufacturer.
Cleaning:
Automated Not applicable
Appendix
B