4
Congratulations on purchasing a Full Boar Plasma Cutter.
Your Full Boar Plasma Cutter FBT-2500 has been designed for
cutting different metal types including, steel, stainless steel,
aluminium and other non-ferrous materials.
Warning!
When using mains-powered equipment, basic safety
precautions, including the following, should always be followed to reduce
risk of fire, electric shock, personal injury and material damage.
Read and understand the manual prior to operating this tool.
Save these instructions and other documents supplied with this tool for
future reference.
This tool has been designed for 230V and 240V only. Always check that the power
supply corresponds to the voltage on the rating plate.
Note:
The supply of 230V and 240V on Ozito tools are interchangeable for
Australia and New Zealand.
If the supply cord is damaged, it must be replaced by a qualified electrician or a
power tool repairer in order to avoid a hazard.
Using an Extension Lead
Always use an approved extension lead suitable for the power input of this tool.
Before use, inspect the extension lead for signs of damage, wear and ageing.
Replace the extension lead if damaged or defective. When using an extension lead
on a reel, always unwind the lead completely. Use of an extension lead not suitable
for the power input of the tool or which is damaged or defective may result in a
risk of fire and electric shock.
!
INTRODUCTION
SAFETY INSTRUCTIONS
ELECTRICAL SAFETY
