9
OPERATION
1.
Before drilling, do a test run without load to ensure the position is correct.
2.
Loosen the carriage lock (7) and lower the core drill by turning the
feed handle (8).
3.
Rotate the feed handle (8) in the opposite direction to raise the core drill.
4.
If the position is correct, then operate the core drill as per the core drill manual.
Removing the core drill
WARNING!
Ensure the power tool has been switched off and
disconnected from the power supply and completely stopped before
performing any of the following operations.
1.
Close the water supply tap and disconnect the water supply from the core drill.
2.
Tighten the carriage lock (7) to prevent the carriage (1) from moving when
removing the core drill.
3.
Using a hex key (13) remove part of the collar (2) and remove the core drill.
4.
Re-attach the removed part of the collar (2) for safe storage.