10
OPERATION
Varying the speed
T
he multi purpose mixer has a variable speed dial (7) with constant electronics and
a gear selecting dial (8), which allows the mixer to obtain speeds from 0-750/min
(1st gear: 0-460/min, 2nd gear: 0-750/min).
Adjusting the variable speed dial
With constant electronics the set speed is kept constant even when working under
load.
To adjust the speed rotate the variable speed
dial (7) (fig. 5).
1.
To increase the speed rotate the variable
speed dial (7) to a higher speed, or the
highest number “6” setting.
2.
To reduce the speed rotate the variable
speed dial (7) to a lower speed, or “1”
setting.
Note:
Always reduce the speed when submerging the mixer in the material or
lifting it out. Once the mixer is fully submerged, increase the speed again to ensure
that the motor is adequately cooled.
Changing gears
The gear selector dial (8) enables you to work within a specific speed range. To
adjust the speed rotate the gear selector dial (8) (fig. 6)
1.
Dial position, setting 1 - low speed
(0-460/min), high torque.
2.
Dial position, setting 2 - high speed
(0-750/min), low torque.
Note:
The gears may require the mixing shaft to
be slightly rotated to allow the gears to change.
Fig. 5
Fig. 6
WARNING!
To avoid damaging any gears, ensure the mixer has
completely stopped before changing gears.