Page 3 of 5
20
-
Rev B
17 719
Fulham Co. Inc.: 12705 South Van Ness Ave., Hawthorne, CA 90250 Tel.: 1-323-779-2980 Fax.: 1-323-754-9060.
Specifications subject to change without notice.
[email protected] www.fulham.com
CONDUIT ENTRY
1. Drill a 3/4" hole through the desired conduit entry
knock out located on the top or side of
the frame of the sign.
2. Route the AC input conduit into housing.
3. All conduit connections must use UL LISTED
and SUITABLE FOR WET LOCATION parts.
4. To finish installation of EXIT sign, reference Wall, Ceiling or End Mount instructions.
FLEXIBLE CONDUIT ONLY!
OPERATION (BATTERY BACKUP)
1. Apply AC power to the unit. The LED indicator will be RED.
2. After the battery has been left to charge for 2 hours, test the unit by pushing the
switch. The LED indicator turns OFF and the LED board stays ON.
3. When the switch is released, the LED indicator turns back to RED and the LED board
stays ON.
MAINTENANCE
Caution: Always turn off AC power to the equipment before servicing. Servicing should be
performed only by a qualified service technician. Use only MANUFACTURER supplied
replacement parts.
BATTERY:
The battery supplied with the EM model requires no maintenance. However, it should
be tested periodically and replaced when it no longer operates the connected sign for the
duration of a 30-second or 90-minute test.
GENERAL INSTALLATION GUIDELINES
FOR WET LOCATION EXIT FIXTURE
(FHEX26/FHEC34)
