-6-
INSTALLATION
Connection of the inlet hose
Faucet:
Installation and connection of the Inlet hose
The faucet must be with G3/4" standard screw thread. If not , it is
impossible to connect the inlet hose properly.
NOTE:
water supply faucets should be readily accessible to
permit turning them off when washer is not being used.
Refer to Section on Water Supply Requirements before connecting water inlet
hoses.
1. Connect the water inlet hose to the connector by turning the connecting nut.
RUBBER RING
CONNECTING
NUT
Note:
The washing machine is to be connected to the water mains using new
hose-sets supplied with the appliance, old hose-sets should not be re-
used.
Ⅰ
. About faucet
COLD
HOT
WATER INLET HOSE
COLD WATER
CONNECTOR
HOT WATER
CONNECTOR
CONNECTING
NUT
ELBOW
A: If you just have one water supply line (cold or hot water), connect the inlet hose to
the cold water connector. Do not u
nscrew the lid of hot water connector.
. About washing machine
To prevent water leakage, please ensure the connecting nut is tightened
securely. If water leakage, check the nut whether it is filled with rubber ring.
RUBBER RING
IMPORTANT:
In this situation you can not set wash temperature to WARM OR HOT.
LID OF HOT WATER
CONNECTOR
