27
GB
6.1
PRELIMINARY OPERATIONS
Before starting up the machine, ensure that:
- The supply cable plug is connected to the socket.
- The water supply hose is connected to the tap.
- The tap is open.
- The drain hose is connected according to instructions.
BEFORE USE
6
6.2
ADDING DISHWASHER SALT
Suggestions: for safety reasons, we suggest loading the dishwasher salt before starting the
wash cycle programme.
Only use salt specifically intended for dishwashers; other types of salt (e.g. table salt) often contain
insoluble substances that may clog the water softener and prevent it from working.
Soft water (poor in calcium) is recommended for washing, to prevent limescale deposits on crockery
or in the dishwasher.
To determine the hardness of the water, contact the local water department or use the water hardness
test kit supplied.
If the dishwasher model
is not equipped with a salt compartment
, skip paragraph 6.2.
Set the water softener device on setting D1 when using it for the first time, and follow
the instructions below.
I
‘Hidden’ control panel
D
6.3 Adjusting the water softener device (DISPLAY control panel version)
Note: The salt level indicator on the Display is deactivated when position D1 is used.
A good practice to keep the salt tank full even with the use of detergent tablets.
D
Pull the handle towards you: the door opens easily. If this operation is
done while the dishwasher is in function, a safety device switches the
dishwasher off.
The dishwasher is equipped with a water softener device (Fig. 5) that
automatically regenerates at regular intervals thanks to the salt solution.
Dishwasher salt consumption therefore depends on the hardness of the
local water supplied.
• Open the door and pull out the lower rack.
• Unscrew the salt compartment cap in an anti-clockwise direction.
Using the dishwasher for the first time:
• Pour approximately 1/2 litre of water in the salt compartment.
•
Pour the dishwasher salt into the compartment using the funnel
(about 1-1.5 kg).
• Wipe off any spilt salt from the compartment opening.
To reach an optimal regeneration setting, keep
(for 10 sec.)
the
button
DELAY
(fig. 7) pressed when turning on the appliance.
Now, the current setting is being displayed
(e.g., d4)
. To modify
the setting (within
6
seconds), press the same button again until
the desired level is reached
(see table)
.
Wait for
6
seconds without modifying the setting. A buzzer sound
will indicate that the new setting was accepted. On the
display
,
the request select programme will appear.
d1
d2
d3
d4
<10
>10 <25
>25 <40
>40 <60
>= higher / <=lo
wer
<5,6
>5,6 <14
>14 <22,4
>22,4 <33,6
d5
>60
>33,6
French
degrees
German
degrees
Regeneration
levels
5
I
• Screw the compartment cap back on in a clockwise direction.
• If washing does not take place soon after introducing the dishwasher salt, launch the SOAK pro
-
gramme in order to wash away any excess salt granules.
Summary of Contents for Milano FDW 8207
Page 1: ...LAVAGGIO FDW 8207 ...
Page 2: ......
