Fulgor Milano F4DWS24SS1, User Manual

Page: 32 / 40

USA-CAN - 29
9. MAINTENANCE AND CLEANING
WARNING : Before cleaning or carrying
out maintenance, switch off the appliance,
disconnect the mains plug and turn off the
water tap.
Your dishwasher can only be repaired
by an authorized service agent. Do not
try to repair your machine unless any
recommendation by this manual
WARNING :
All surfaces are susceptible
to scratching. Contact with unsuitable
cleaning agents can alter or discolor all
surfaces.
WARNING : Keep the floor around
your dishwasher clean and dry to prevent
any possible injury. We recommend to
keep your dish washer clean,empty and
door cracked open to allow air to circulate
in case of any extended unused time.
Dishwasher door can be damaged by
abrasive cleaners, scouring pads, abrasive
cloths. Cleaning the machine in regular
intervals prolongs the machine’s service life.
Oil and lime may accumulate in the
machine’s washing section. In case of
such accumulation; -Fill the detergent
compartment without loading any dishes
into the machine, select a program that runs
at high temperature, and start the machine.
In case of insufficiency, use special
cleansing material available in the market.
(Cleansing material produced special to
machines by detergent producers.)
Cleaning the seals in the machine door,
- To clean any accumulated residues in
the door seals, wipe the seals regularly by
using a dampened cloth.
Cleaning the machine,
Clean the filters and spray arms at least
once a month.
Unplug your machine and turn off its tap
before starting the cleaning.
Do not use hard materials when cleaning
your machine. Wipe with a fine cleaning
material and a dampened cloth.
Filters
Check if any food wastes have remained
on the coarse and fine filters. If any food
wastes are left, remove the filters and clean
them thoroughly under the water tap.
9.1 Filter
a. Micro Filter
b. Coarse Filter
c.
Metal/Plastic
3 4
1 2
a
c
b
9.2. Spray Arms
Check whether or not the holes for the
upper and lower spray arms are clogged.
If there is any clogging, remove the spray
arms and clean them under water.
You can remove the lower spray arm by
pulling it upwards, while the upper spray
arm nut can be removed by turning the nut
to the left.
Be sure that the nut is perfectly tightened
when refitting the upper spray arm.