Fulgor Milano F4DWS24SS1, User Manual

Page: 16 / 40

USA-CAN - 13
5.4. Salt Refill Indicator
(Model Depending)
WARNING: If the salt indicator light
comes on during a program you need to
wait until the end of the program to fill the
salt reservoir with dishwasher salt.
After the salt reservoir has been filled, the
refill indicator may still be lit up if the salt
concentration has not yet reached the
correct level. It will go out when the correct
concentration is reached.
NOTE: The salt refill indicator will be
turned off if you have programmed the
dishwasher for a water hardness below 9 °f.
5.5. Detergent Usage
WARNING: Use a detergent
specifically designed for use in
domestic dishwashers.
You can find powder, gel,and tablet
detergents in the market that have been
designed for household dishwashers.
Detergent should be put into the
compartment prior to starting the machine.
Add the proper detergent for the selected
program to ensure the best performance.
Use less detergent if the dishes are only
lightly soiled. Using excess detergent can
leave a film on dishes and in the
dishwasher resulting in poor wash
performance. Do not use detergent tablets
for shorter wash cycles. The tablet may not
dissolve completely, causing detergent
residue on dishes and inefficient
cleaning.
NOTE: The amount of detergent
needed depends on the cycle, load size,
and soil level of dishes. Too much detergent
in soft water may cause glass corrosion and
does not dissolve in water.
WARNING: Do not use too much
detergent if your water supply is soft.
WARNING: Keep your detergents in
cool, dry places out of reach of children.
See the detergent manufacturer’s
instructions for further information.
WARNING:
Detergent tablets do not
fully dissolve with short programmes.
To prevent detergent residues on the
tableware, we recommend that you use the
tablets with long programmes.
WARNING: Do not use detergent in
Rinse cycle (model depending).
If you do not know the hardness of your
water supply, use 15 ml / 3 tsp detergent.
Increase the amount of detergent if you see
white water marks especially on the surface
of the glassware.
Should you need more information
concerning the detergent you will use,
contact detergent manufacturers directly.
Check that the detergent dispenser is
empty after the completion of each wash
program
5.6. Filling The Detergent
NOTE: The dispenser should be refilled
just before the start of each program.
1. Push the latch to open the detergent
container as shown in the image( fig 1).
DETERGENT
2. Pour/put the detergent into the dispenser.
( fig 2)
3. Detergent pod has level lines inside. It is
possible to measure the right detergent
amount using these lines. Detergent pod
can take totally 40 cm³ detergent. Open