6
POWER SUPPLY
1. Plug the auxiliary cable to PC port 19V 3.5A of the NOMAD POWER.
2. Select the appropriate connection for your laptop and connect it on the auxiliary cable.
3. Plug the auxiliary cable with the right connection on the power supply socket
of your laptop.
4. Press the ON button to start the charge
1. Plug the auxiliary cable (not supplied) to the 12V 12A NOMAD POWER port.
2. Plug the auxiliary cable (not supplied) to your 12V device.
3. Press the power button.
FLASHLIGHT FUNCTION
Press the power button for 3 seconds to activate the LED.
Briefly press the button to switch lighting modes.
(4 available modes: normal, flash, SOS and OFF)
PROTECTIONS
This device is protected against short-circuits, overloads, deeply discharge and polarity inversions.
TROUBLESHOTING, CAUSES, REMEDIES
TROUBLESHOOTING
CAUSES
REMEDIES
1
No response while pressing
the ON/OFF button
The NOMAD POWER is discharged. Charge the product (see page 4).
2
"Error" light ON on the
jumper cable.
Internal battery voltage < 11.0V.
Charge the product.
3
"Error" light flashes red +
alarm beep.
Polarity reversal
Check that the clamps are well connected and unplug/plug back the jumper cable.
Short-circuit
Check that the clamps are well connected and unplug/plug back the jumper
Clamps have been left connected
to the battery.
Remove the 2 clamps from the car battery in order to protect the device.
4
The device is warm whilst
connected to a laptop
-
Remove laptop’s battery or unplug the NOMAD POWER from the laptop for 5
minutes and plug it back again.
