Remote Control
Fit the supplied 2pc x AA alkaline batteries, taking care with correct polarity.
The Remote’s keypad can set the following functions:
1. Rotating speed in increments; slow for Indoors, fast (max) for Outdoors.
2. Scan angles in increments.
3. Scan line position around the room.
4. Auto / Manual (grade) settings via top middle button.
5. Four ARROW buttons to set required X/Y grades.
TIP
- it is often better to use the Remote Control rather than the instrument's
keypad, because then you do not disturb the laser's sensitive mechanism.
Laser Detector
Fit the supplied 9V battery, polarity marked. Power up via ON/OFF button.
The top button switches the sounder' volume ON or OFF - if required.
The middle button sets coarse (+/-2mm) or fine (+/-1mm) red pick-up
window resolution.
A rear LCD repeats the main front display.
Note: the case markings & setting notches.
You can use the detector with or without its staff mounting bracket.
Detector Procedure
– face towards rotating laser & "find" rotating laser
beam via the red pick-up window.
If the sun is low in the sky & shining into the red window, shield it with a
cupped hand to prevent false readings. Positioning the FRE-301R itself in full
sun is no problem, but the detector window can, in some instances, be
affected by direct bright sunlight or reflections. So please take extra care!
SAFETY PRECAUTIONS:
Comply with class 2 laser operating safety procedures. See main Manual.
Display a
Laser Safety Notice
in the work area.
General Advice:
This is an accurate measuring device - so to give good service, look after it!
Prevent the FRE-301R from receiving severe knocks, bangs or vibration.
Store the laser & its accessories in the supplied carry case.
If wet, dry before storing & keep in storage temps between 5-30 deg C.
Remove all batteries before long term storage, to prevent internal damage.
5
