FACTORY RESET PROCEDURE
23
Fukuda FRE-205 Factory Reset Procedure
●
Place the FRE-205 on a fi rm surface (within ±5 degrees of true level).
●
Press the ON/OFF button once and the FRE-205 will power on. The red LED beneath the
green button should be ON. Due to the fault, the laser beam will be fl ashing ON & OFF, but
the prism head will not be rotating.
●
Point the Remote Control towards the FRE-205 and press the Manual Override button
(middle top button) once on the remote.
This changes the operating mode of the laser from
Auto to Manual levelling.
●
The “X” axis green LED should illuminate, and the laser will rotate. Press the Rotational Speed
Control - Tortoise/Hare on the Remote Control (top left hand button), if necessary.
●
Whilst watching the Laser Prism (avoiding direct eye contact with the actual laser beam) hold
down the
Plus
button until the Laser prism tilts fully over to one side and then stops and the
beam starts fl ashing.
●
Hold down the
Minus
button until the Laser prism tilts over fully to the other side and then
stops and the beam starts fl ashing.
●
Then hold down the
Plus
button, but this time until the laser head returns to the centre.
When the laser prism is back to the centre, release the
Plus
button.
●
Press the
X/Y
button once on the Remote Control and the the “Y” axis green LED should now
illuminate.
●
The Laser Prism will continue to rotate.
●
Whilst watching the Laser Prism (avoiding direct eye contact with the actual laser beam) hold
down the
Plus
button until the Laser prism tilts fully over to one side and then stops and the
beam starts fl ashing.
●
Hold down the
Minus
button until the Laser prism tilts over fully to the other side and then
stops and the beam starts fl ashing.
●
Then hold down the
Plus
button, but this time until the laser head returns to the centre.
When the laser prism is back to the centre release the
Plus
button.
●
These steps have made the control motors move over their full range and in most instances, will
rectify the levelling fault.
●
Finally, press ON/OFF button once and the FRE-205 will turn off . Wait a couple of seconds and
then press Press the
ON/OFF
button once again and the FRE-205 will power on and begin
automatically self-levelling horizontally. The FRE-205 should now be operating correctly.
The following procedure is a possible cure for the following fault:
“Laser Prism tilted over to one side and it will not rotate”
Prior to starting, please ensure that the batteries in the FRE-205 are fully charged and the
Remote Control is operating (the red LED will illuminate when of any of its six buttons are
pressed). If not, replace the remote control batteries.
