laser. The Mains Charger (supplied) will charge these batteries in around 7 to
8 hours to give up to 30 hrs of continuous use. It takes 4 to 5
charge/discharge cycles for this battery pack to reach its maximum capacity.
A Spare Battery holder
incl. in the kit for use as a "back-up" power source:
Option 1.
Rechargeable pack with black charge socket.
Option 2.
Standard (non-rechargeable) Battery pack. It holds 4 x type C,
1.5V Alkaline batteries to be used instead of the rechargeable battery pack or
in an emergency. (It has no black charging socket).
Mains Charger:
The general procedure to adopt is to use the laser during the working day &
charge-up overnight. You cannot damage the system by "over-charging" the
batteries. When plugged into a 230V mains supply, the red LED flashes every
one second. Connect to the rubber protected socket (located on the front of
the battery pack), then the Charger's LED should be ON continuously:
ie. Red LED = charging; Green LED = sufficient charge to operate.
Even though the Green light is ON, we still recommend a full 8 hour charge.
The FRE-102AR can be operated with the charger connected to the mains
supply, if required.
On receipt of your
new
laser, charge the batteries fully for 6-8 hrs.
Positioning the Laser:
Mount the FRE-102AR on a generally level, firm surface or 5/8” threaded
Tripod.
To operate correctly this surface must be /-5 deg of true horizontal.
(WARNING: green "X" & "Y" LED's flash on/off, if laser is outside 5 deg
range.)
The laser can be used Indoors or Outdoors, where it is waterproof to IP55.
2