66
Troubleshooting
[Symptom] The power cord is inserted to the power outlet, but the XG2000R does not turn on.
[Cause]
Possible causes:
1 The power cord is loosened or pulled out.
2 Hardware failure.
[Action]
In the following sequence:
1 Check that all power cords are connected properly. Try substituting power cords.
2 If the XG2000R fails to power on then contact the vendor's service department.
[Symptom] The XG2000R has not started within a few minutes of power on and the Status LED
keeps blinking.
[Cause]
Probable hardware failure.
[Action]
Contact the vendor's service department.
[Symptom] The XG2000R has not started within a few minutes of power on and the Alarm LED
(Orange) lights.
[Cause]
Probable hardware failure.
[Action]
Contact the vendor's service department.
3-1
Start-up Problems
The following errors may occur when the XG2000R is started up.
If the cause of the error cannot be resolved, contact the vendor's service department.
The following explains some general errors that can occur. Check if any of these match your prob-
lem.
The XG2000R does not turn on
Status LED blinks, but the XG2000R does not start up
Alarm LED lights, but the XG2000R does not start up
Summary of Contents for XG2000R
