Fujitsu UTP-VX30A, Service Manual

Page: 60 / 255

03-20
7
8
NOTES
To delete the operating time
5
6
Operating setting
Raise
Lower
Press the Start/Stop button or the Mode button or the Set Temperature button to set
the operation.
* For the operations that can be set, refer to "Operation mode setting", "Room tem-
perature setting", and "To start /stop operation" , in "OPERATION".
* Only the current operation settings are displayed.
ex.TIMER-1 will start operation at 8:00 on COOL.
Setting the next timer for the same day:
TIMER-1 TIMER-2 TIMER-3 TIMER-4
Then press the ENTER button to proceed to the time setting, and repeat steps from to .
4 5
Repeat steps to to set the timer for another day of the week.
3 5
Be careful for pressing the ENTER button without any operation setting because the time that is set will be
cancelled.
When the operating time is set, the mark appears.
ex. TIMER-1 will start operation at 8:00 on COOL with a set-
ting of 20 C
1. Press the ENTER button to confirm the set timer.
2. Press again the PROGRAM (CLOCK ADJUST)
button to complete the weekly timer setting.
* flashes for two seconds.
ı ˇ ı
Setting the timer for the other indoor units:
Before setting the timer for other indoor units, press the ENTER button to confirm the
settings.
* The display switches to the next timer.
Repeat steps to to set the timer for other indoor units.
2 6
1. If the Timer Mode (DELETE) button is pressed during steps to , the operat-
ing time for the selected day will be deleted.
* If all the days are selected, the operating times for all of the days of the se-
lected timer will be deleted.
2. Press the ENTER button to confirm the deletion.
3 7
AM
(1) The WEEKLY timer does not operate when the HEAT timer is set if a HEAT PUMP MODEL in the air conditioning system
is operating in the cooling mode. In addition, the WEEKLY timer does not operate when the COOL or DRY timer is set if
a HEAT PUMP MODEL in the air conditioning system is operating in the heating mode.
(2) Even if the timer operation is set, the timer lamp of the indoor unit does not light up. (The timer lamp is used for
wireless remote controller only.)
(3) If the same time is set in Timer-1 to Timer-4 of an indoor unit, the timer setting of the smallest number will be effective.