25
&
Advice
&
The [Initialize] tab is used for initializing the setup settings.
>>Reference>> “3.7.2 Initializing the setup settings”
(6) Tap on the [Yes] button on the [Save Settings] window.
Tap on the [No] button to terminate the setup without saving any information that has been set
during the setup.
Ø
The information set during the setup is not saved, and the power supply of this unit is
automatically turned off if the [Yes] button has been tapped.
NOTE
It takes a few seconds for the power supply of this unit to be automatically turned off.
The [PWR] key must not be pressed before the unit powers off automatically.
3 Using The TeamPad 7500 Series Units
3.1 Turning on/off the Power Supply
3.1.1 Turning on the power supply
(1) Press the PWR key while the power supply is being turned off.
Ø
The power supply is turned on.
The LED is lit in green while the screen is not displayed.
NOTE
•
There might be a possible hardware fault if the LED flashes red for 5 seconds at an
interval of about 0.5 seconds. Contact a field support service representative.
•
The [Change setting] window for network settings is displayed by pressing the [PWR]
key when this unit has not set up, or when the setup settings have been initialized.
Press the [PWR] key again after performing the setup.
>>Reference>> “2 TeamPad 7500 Setup” about the setup.
&
Advice
&
This unit will automatically attempt to connect to the server by turning on the power
Summary of Contents for TeamPad PBT7500-16
Page 19: ...6 ...
