Fujitsu Stylistic 3500, Technical Reference Manual

Page: 51 / 110

Peripheral Interface Specifications 41
Peripheral Interface Specifications 5
Specifications for peripheral interfaces on the Stylistic 3500 pen tablet are given in Table 5-5. For
specifications on peripheral interfaces provided by the port replicator, see “Port Replicator Specifications”
later in this chapter. Also note that pin assignments and other details for peripheral interfaces on the
Stylistic 3500 pen tablet are given in Chapter 6 of this manual.
Table 5-5. Peripheral Interface Specifications
Feature Specification Comments
PC Card Slot One Type II PCMCIA CardBus slot.
Compliant with PC Card Standard Rev. 3.0 Supports CardBus and PCIC (PC Card I/O
Cards)
IDE Interface Supports one IDE hard disk drive (2.5 inch) IDE hard disk drive is preinstalled at factory.
Modem Port RJ-11 connector for internal modem See “Internal LAN/Modem Specifications” on
page 44 for more information. Note that the
LAN portion of the device is accessible only
via the mini-dock.
Serial Port Standard 9-pin connector that allows you to
connect an external serial device.
Universal Serial Bus
Port (USB A) One USB Series A receptacle on pen tablet.
IrDA Port Infrared transceiver built into pen tablet. Compliant with IrDA Standard Revision 1.1
Supports: FIR (4 Mbps max),
SIR (115 Kbps max)
Range: approximately 1 M, 15 degrees from
center
Infrared Keyboard
Port Infrared receiver built into the pen tablet for
use with an optional infrared keyboard. Proprietary Fujitsu receiver.
Range: approximately 1 M, 15 degrees from
center
DC Power Input 16 VDC ±10%, 3.36 A
Connector vendor: Hosiden
(Hosiden part number HEC3900-01-010)
This connector is a EIAJ-RC5320A standard
connector. External power can be connected to DC
input connector on the pen tablet, mini-dock,
port replicator, or high-usage contacts. See
“DC Power Inputs” on page 67 for more
details.
Audio Jacks Monaural microphone input mini jack
Stereo headphone output mini jack Standard 3.5 mm mini jacks.
See “Audio Jacks” on page 59 for details on
audio inputs and outputs.
System Interface
Port 200-pin connector For use with Stylistic 3500 port replicator or
mini-dock.
High-Usage
Contacts 8-position external contact connector
provides connections for: DC power input and
USB. See “High Usage Contacts” on page 47 for
signal assignments of the high-usage
contacts.
Floppy Disk Drive
Port 26-pin floppy disk drive connector For use with Fujitsu floppy disk drive.