Fujitsu SPARC Enterprise T5140, Installation Manual

Page: 59 / 130

Installing the SPARC Enterprise T5140 and T5240 Servers 37
Note – This port is not operational until you configure the network settings (through
the serial management port), as detailed in “To Configure the Service Processor
Network Management Port” on page 52 .
●
Connect a Category 5 cable from the NET MGT network management port to
your network switch or hub.
FIGURE:
Service Processor Network Management Port – Rear Panel
Related Information
■
“To Connect the Ethernet Network Cables” on page 38
To Connect the Ethernet Network Cables
The server has four network connectors, marked NET0, NET1, NET2, and NET3
(
FIGURE: Service Processor Ethernet Network Ports – Rear Panel on page 39 ). These
connectors are RJ-45 Gigabit Ethernet.
Related Information
■
“To Connect the Cables” on page 39