Change odd page title here
Chapter 5 Programming the internal Flash memory
© Fujitsu Semiconductor Europe GmbH
- 33 -
FMEMCU-UG-960031-13
3) After programming the Flash-device, switch off the power supply and set back the
mode according to the usage of the application, e.g.:
Note:
JP51
don‟t care
Note:
JP51 closed
4) Power on the board. The user application is started directly.
5.2 Synchronous Mode
In order to program the Flash-ROM synchronously special third-party soft- and hardware has
to be used, e.g. GALEP-4 from
www.conitec.de
. This tool is not available for free.
A dedicated Flash programming socket (X4) is provided on the evaluation-board for direct
connection to this programmer.
X4: Flash programming socket
Figure 5-1: Flash Programming Socket
Note:
Please open the jumpers JP37 (SIN2) and JP39 (SOT2), in order to avoid that the
synchronous programming tool drives against the on-board RS232 transceiver!
On
Off
1
2
3
4
DEBUG I/F
P17_0
MD
nc
DIP Switch:
RUN Mode
On
Off
1
2
3
4
MD0
MD1
MD2
nc
MB96600
MB96300
n/c1
DEBUG I/F 3
RST 5
SOT2 7
VCC 9
2 n/c
4 n/c
6 SIN2
8 SCK2
10 GND
