Fujitsu PRIMERGY, User Manual

Page: 41 / 56

11
E
Advanced Configuration Options Default setting
Reset SCSI Bus at IC Initialization Enabled
Host Adapter BIOS (Configuration Utility Reserves Enabled
BIOS Space)
Support Removable Disks Under BIOS as Fixed Disks *
2
Boot only
Extended BIOS Translation for DOS Drivers > 1 Gbyte * 2 Enabled
Display <Ctrl-A> Message During BIOS Initialization *
2
Enabled
Multiple LUN Support * 2 Disabled
BIOS Support for Bootable CD-ROM * 2 Disabled
BIOS Support for Int13 Extensions * 2 Enabled
Support for Ultra SCSI Speed * 3 Enabled
*2 To be "Enabled" only when the "Host Adapter BIOS" is set to ｢Enabled｣.
*3 When the "Support for Ultra SCSI Speed" is set to ｢Enabled｣ and the "Initiate Wide Negotiation" is set to ｢yes｣, the setting
value of the "Maximum Sync Transfer Rate" is 40 MB/s.
■
Explanation of each setting
1
SCSI Bus Interface Definitions
・ Host Adapter SCSI ID
Selecting this option allows you to set the SCSI ID of this card. The default
setting is SCSI ID=7. This card has the highest priority on the SCSI bus. We
recommend that you leave this card ID set to 7.
・ SCSI Parity Checking
Selecting this option allows you to determine whether data is transferred
accurately on the SCSI bus or whether this card checks the parity. The default
setting is ｢Enabled｣. If any SCSI device being connected to this card does not
support the SCSI parity function, ｢Disabled｣ the SCSI Parity Checking
function. Most SCSI devices support SCSI parity. If you do not know
whether the SCSI device supports SCSI parity, refer to that SCSI device's
documentation.
・ Host Adapter SCSI Termination
This option allows you to configure SCSI termination using this card. This
card default setting is ｢Automatic｣. We recommend that you leave this card
set its default setting of ｢Automatic｣.
Note
The SCSI terminators of this card are always activated because the
jumpers J2 and J4 of this card are short-circuited.