Fujitsu PRIMERGY TX2550 M5, Upgrade And Maintenance Manual

Page: 271 / 636

▶
Connect the power cable C6 to the connector "PWR3" on the system board.
▶
If applicable, connect the OOB cable, see "Replacing the OOB cable" on
page 554 .
For the cable plan, see "Appendix B" on page 589 .
Installing HDD modules into the 8x 2.5-inch HDD/SSD extension box
▶
"Reassembling" on page 68 .
▶
Install HDD modules or HDD dummy modules into the additional HDD bays,
see
"Installing a 2.5-inch HDD/SSD module" on page 219 and "Installing a
2.5-inch dummy module" on page 222 .
For more information on HDD mounting order, see "2.5-inch HDD/SSD
configurations" on page 202 .
Concluding steps
▶
Install the fan bridge, see "Handling the fan bridge" on page 92 .
▶
"Installing the system air duct" on page 68 .
▶
"Reassembling" on page 68 .
▶
"Connecting the power cord" on page 82 .
▶
"Switching on the server" on page 83 .
▶
Update the system information of your server using the Chassis ID Prom
Tool, see
"Using the Chassis ID Prom Tool" on page 136 . Select the
corresponding system name.
▶
"Resuming BitLocker functionality" on page 130 .
7.6.3 Removing the 8x 2.5-inch HDD/SSD extension
box
Upgrade and Repair Unit
(URU) Hardware: 10 minutes
Software: 10 minutes
Hard disk drive (HDD) / solid state disk (SSD)
TX2550 M5 Upgrade and Maintenance Manual 271