U41100-J-Z156-1-74
5
PRIMERGY S40-DF capacity extension Converting the PRIMERGY S40-DF
1.4
Converting the PRIMERGY S40-DF
In order to install expanded storage capacity using one or three PRIMERGY
S40-ES storage subsystems, you will need the corresponding conversion kit.
This conversion kit contains the following components:
–
an LVD extender board (3-channel version and 1-channel version)
–
an OLR/STM-LVD flat ribbon cable (3-channel version)
Proceed as follows:
Ê
Unpack all the components.
Ê
Check the contents of the package for any visible damage resulting from
transportation.
Ê
Verify that the delivered components match those listed in the delivery note.
If you detect any damage resulting from transportation or any deviations in
the supplied contents and the delivery note, please contact your vendor
immediately!
Floorstand and stackable models
Ê
Make sure that the storage subsystem is freely accessible from the front and
the back.
Ê
Switch off the storage subsystem and disconnect it from the power supply.
V
CAUTION!
Note that switching off the device does not disconnect it from the
power supply. To ensure that the device is fully disconnected from the
power supply, you must pull out the power plugs.
Ê
Remove the door (see section “Removing and mounting the door” on
page 8).
Ê
Remove the left side cover for the floorstand model or the top cover for the
stackable model (see section “Removing and mounting the side or top
cover” on page 9).
Ê
Remove the protective shield for the SCSI area of the storage subsystem
(see section “Removing and mounting the protective shield” on page 10).
