Fujitsu PRIMERGY RX2520 M5, Operating Manual

Page: 61 / 98

RX2520 M5
Operating Manual 61
Starting up
Information for ensuring electromagnetic compatibility
All data and signal cables must have sufficient shielding. The use of cable type
S/FTP Cat5 or higher is recommended.
Use of unshielded or badly shielded cables may lead to increased emission of
interference and/or reduced fault-tolerance of the device.
5.4.2 Connecting devices to the server
The connectors for external devices are on the front and rear of the server, see
section
"Connectors on the server" on page 24 .
I
For a remote installation using the ServerView Installation Manger a LAN
connection is necessary.
I
Some of the devices that can be connected may require special
software, e.g. drivers (see the documentation for the connected device).
Connecting the keyboard, mouse and monitor
Ê
Connect the keyboard and mouse to the USB connectors of the server.
Ê
Connect the monitor to one of the two video connectors at the front or rear.
I
The front video connector is designed for maintenance issues. If you
connect a monitor to the video connector at the front, the video
connector at the rear is deactivated. A monitor connected to the front
must have at least the same resolution as the monitor connected to
the rear. A console bypass is not possible via the video connector at
the front.
I
If a separate graphics card is installed in a slot, the graphic controller
on the system board is automatically deactivated. The corresponding
video connector can not be used. Connect the video cable of the
monitor to the video connector of the graphics card.
Ê
Connect the power cord of the monitor to a power outlet of the rack socket
strip.
I
The rated current for the monitor is indicated on the technical data label
on the monitor or in the operating manual for the monitor.