Fujitsu PRIMERGY RX200 S6, Options Manual

Page: 33 / 84

RX200 S6
Options Guide 33
Main memory
– In the case of same number of ranks install the memory module with the
highest capacity into the slot with lowest number (e.g. 8GB 2Rx4 modules
(DIMM-1A) before 4GB 2Rx4 modules (DIMM-2A)).
– In Mirrored Channel Mode and in Spare Channel Mode, memory modules of
different capacities may be mixed on a bank by bank basis.
– The assignment of the DIMM slots to the memory banks and channels is
imprinted on the system board next to the DIMM slots.
5.2 Expanding the main memory
Ê
Open the server as described in the chapter "Preparation" on page 25 .
Ê
Remove the air duct as described in the section "Removing the air duct" on
page 29 .
Figure 6: Removing a memory module
Ê
Press the securing clips on both sides of the memory slot concerned
outward.
Ê
If the slot was equipped: pull the memory module out of the slot (2).
1
1
2