Econel 50
Service Supplement
21
Replacement Routines
Replacing the USB Connector Cable
4.4
Replacing the USB Connector Cable
Ê
Remove the left side cover and the front panel as described in section
“General Purposes” on page 13.
Ê
Disconnect the power supply cable (connector P4) from the floppy disk drive.
Ê
Disconnect the data cable T26139-Y1248-V8 from the floppy disk drive.
Ê
Detach the USB connector cable T26139-Y3894-V2 from the connector
USB1/2 on the system board (see D1859 sticker).
Ê
Remove the slide-in unit with the floppy disk drive from the location by
pressing together the two springs of the EasyClick rails until they are
unlocked (see also section “Replacing the Floppy Disk Drive” on page 19).
Figure 9: Removing the front bezel from the slide-in unit
Ê
Disengage the locking mechanism (1) and remove the front bezel from the
slide-in unit.
2
1
1
Summary of Contents for PRIMERGY Econel 50
