Fujitsu PRIMERGY BX922 S2, Options Manual, Page: 18 / 70

18 Options Guide
BX922 S2
Safety instructions
●
Transport the device only in the original packaging or in packaging
that protects it from knocks and jolts.
For the Japanese market it is not required to transport the device in
its original packaging.
Installation and operation
V
CAUTION!
●
Observe the notes on installation and operation in the operating
manual of your respective basic unit.
●
When installing the server blade in the basic unit, beware of the
energy hazard at the midplane contacts. A short circuit on these
contacts can damage the system.
●
Data cables must be adequately shielded to avoid interference.
●
The EN 50173 and EN 50174-1/2 standards apply for LAN cabling.
The minimum requirement is the use of a category 5 screened LAN
cable for 10/100 Mbit/s Ethernet, or a category 5e cable for Gigabit
Ethernet. The requirements of the specification ISO/IEC 11801 must
also be taken into account.
●
Route the cables in such a way that they do not form a potential
hazard (tripping) and cannot be damaged. When connecting the
device, refer to the relevant notes in the operating manual for the
device.
●
Do not connect or disconnect any data transmission cables during a
thunderstorm (lightning hazard).
●
Make sure that no objects (e.g. jewelry, paperclips etc.) or liquids get
inside the unit (electric shock hazard, short circuit).
●
In emergencies (e.g. damaged casing, control elements or power
cables, penetration of liquids or foreign bodies), switch off the device
immediately, unplug it from the grounded power outlets, and contact
your customer service team.
●
Proper operation of the system (in accordance with IEC 60950/DIN
EN 60950) is only ensured if the casing is completely assembled and
the rear covers for the installation openings have been put in place
(electric shock, cooling, fire protection, interference suppression).