BX620 S4
Operating Manual
41
Installation and Operation
Switching the BX620 S3 Server Blade On/Off
5.2
Switching the Server Blade On/Off
V
ATTENTION!
If you switch the server blade on and the connected monitor only displays
flickering stripes, switch it off again immediately (see
chapter “Trouble-
shooting and Tips” on page 63
).
This section describes how to switch the BX620 S4 Server Blade on and off via
the server blade control panel when the basic unit is running.
With the basic unit, you can also switch the installed server blades on an off via
the control panel of the overall system as well as via the Web interface of the
management blade. For detailed information see the basic unit operating
manual (see
“Related Publications” on page 75
).
Switching the Server Blade On/Off via the Control Panel
The basic unit must be switched on.
You can switch the server blade on or off using one of the following methods:
–
To switch the server blade on, press the On/Off button of the server blade
(position 2 in
figure 7 on page 38
).
To switch the server blade off, press the On/Off button of the server blade
(position 2 in
figure 7 on page 38
) for 4 seconds.
–
Defined switch-on/switch-off time
The server blade is switched on or off at the time defined in
ServerView
.
9
Hard disk drive indicator (orange LED)
Dark:
No error
Glows
orange:
Server blade is on and hard disk drive has an error.
Flashes
slowly (1Hz)
Reconstruction (RAID message)
Flashes
quickly (3Hz)
Identification of hard disk localization (RAID message)
