Troubleshooting and tips
A26361-K632-Z100-1-7619
41
No mouse pointer displayed on the screen
Mouse driver not loaded
Ê
Check whether the mouse driver is properly installed and is present when the application
program is started. Detailed information can be found in the User Guides of the mouse, the
operating system or the application program.
Mouse controller disabled
The mouse controller on the system board must be enabled, if you use the supplied mouse.
Ê
Check in the
BIOS Setup
that the mouse controller is
Enabled
.
The floppy disk cannot be read or written
Ê
Check whether the write protection of the floppy disk is activated.
Ê
In the
BIOS Setup
check the entry for the floppy disk drive.
Ê
Check in the
BIOS Setup
whether the diskette drive controller and write permission are enabled
(see the Technical Manual for the system board).
Ê
Check that the cables of the floppy disk drive are properly connected (refer to chapter "
expansions for tower server
").
Time and/or date is not correct
Ê
Set the time and/or date in the operating system or in the
BIOS Setup
.
i
If the time and date are repeatedly wrong when you switch on your server, the battery is
flat. Change the lithium battery as described in the Technical Manual of the system board.
System will not boot after installing a new hard disk
drive
SCSI configuration incorrect (Ultra Wide SCSI Controller)
Ê
In the SCSI configuration menu check the settings for the hard disk drives (
SCSI Device
Configuration
) and the settings under
Advanced Configuration Options
.