Fujitsu PRIMEQUEST 400 Series, Installation Manual, Page: 47 / 446

C122-E001-10EN 2-1
CHAPTER 2 Setup
1
2.1 Before Starting Setup
The setup procedure roughly consists of steps (1) to (3) below. Before starting setup,
you need to determine the address and other information.
If the power has not been supplied to the main unit or partition, turn on the power by
performing the power-on procedure explained in Appendix C, "Power Control."
Note: The management LAN and the business LAN must be configured on
different subnets.
(1) MMB setup (see Section 2.2 for the procedure)
Before starting MMB setup, you need to determine the following:
• IP address, host name, subnet mask, and gateway address
•
IP address of the PC to be used for the MMB console
• User accounts
•
Name of the PRIMEQUEST system (also used as the SNMP system name)
• Environment used for management VLAN
and others.
(2) Partition setup (see Section 2.5 for the procedure)
If you use the partition function to configure multiple partitions, you must determine
the number of partitions and the following items in advance:
• Partition names
•
Partition configuration
•
Home IOU
•
Boot control
• System Mirror
and others.
Note: Naming each partition the same name as the host name of the OS installed
in the partition makes managing partition an easier task.