Fujitsu MPG3102AT, Product Manual

Page: 137 / 201

C141-E110-03EN 5 - 70
At command issuance (I-O registers setting contents)
1F7
H
(CM) 1 1 1 1 0 0 1 0
1F6
H
(DH)
× × ×
DV xx
1F5
H
(CH)
1F4
H
(CL)
1F3
H
(SN)
1F2
H
(SC)
1F1
H
(FR)
xx
xx
xx
xx
xx
At command completion (I-O registers setting contents)
1F7
H
(ST) Status information
1F6
H
(DH)
× × ×
DV xx
1F5
H
(CH)
1F4
H
(CL)
1F3
H
(SN)
1F2
H
(SC)
1F1
H
(ER)
xx
xx
xx
xx
Error information
(36-1) SET MAX ADDRESS (F9)
This command allows the maximum address accessible by the user to be set in LBA or CHS mode.
Upon receipt of the command, the device sets the BSY bit and saves the maximum address
specified in the DH, CH, CL and SN registers. Then, it clears BSY and generates an interrupt.
The new address information set by this command is reflected in Words 1, 54, 57, 58, 60 and 61 of
IDENTIFY DEVICE information. If an attempt is made to perform a read or write operation for an
address beyond the new address space, an ID Not Found error will result.
When SC register bit 0, VV (Value Volatile), is 1, the value set by this command is held even after
power on and the occurrence of a hard reset. When the VV bit is 0, the value set by this command
becomes invalid when the power is turned on, and the maximum address returns to the value
(default value if not set) most lately set when VV bit = 1.
After power on and the occurrence of a hard reset, the host can issue this command only once
when VV bit = 1. If this command with VV bit = 1 is issued twice or more, any command
following the first time will result in an Aborted Command error.