20
ADDING MEMORY
Where to install memory
Your notebook has an expansion RAM module
slot (slot 2) to add in one additional memory
module.
The memory capacity of the notebook can be
increased to a maximum of 4GB (2048 MB x 2).
Preparing necessary items
•
Philips screwdriver
Use a screwdriver of appropiate size to
remove the screws on the cover. Failure to
do so may damage the head of the screws.
Memory Module Configuration Table.
The table below shows combinations of
memor y size modules that can be
installed on your notebook.
The installation of any combination of memory
size modules other than the combinations shown
below can impair the functioning of your
notebook.
This LifeBook is capable of operating in dual
channel memory mode. To realize the full
performance benefits of dual channel operations,
the two memory slots must be fitted with DDR2
memory modules of the same capacity and
specification. We strongly recommend you to use
only Fujitsu approved memory modules.
Installing memory module
To install memory, perform these steps.
Before installing any memory module,
remember to power off the notebook and
disconnect the AC adapter from it.
Keep small objects, such as a cover, caps
and screws, out of the reach of babies
and children. These small objects may
suffocate a baby or child if they are
swallowed accidentally. Should such an
accident happen, consult a doctor
immediately.
Certain components around the memory
slots are very hot when the notebook is
powerd on for a long period of time.
To avoid possible burns, do not install or
remove memory module immediately
after turning off the notebook. Wait for a
while until its internal components cool
down.
Memory
compartment
cover
Total capacity
Slot 1
Slot 2
256 MB
256 MB
384 MB
256 MB
128 MB
512 MB
256 MB
256 MB
768 MB
256 MB
512 MB
1 GB
512 MB
512 MB
2 GB
1024 MB
1024 MB
4 GB 2048 MB 2048 MB
* Subjected to availiability of 2048 MB memory
modules
LB_GAURA (19-23) EN
13/11/06, 05:33 pm
20