En-3
Fig. 6 Remote Control Unit
J
SLEEP button
K
MASTER CONTROL button
L
SET TEMP. button (
/
)
M
Signal Transmitter
N
TIMER MODE button
O
TIMER SET (
/
) button
P
FAN CONTROL button
Q
START/STOP button
R
SET button (Vertical)
S
SET button (Horizontal)
T
SWING button
U
RESET button
V
TEST RUN button
●
This button is used when installing the
conditioner, and should not be used un-
der normal conditions, as it will cause the
air conditioner’s thermostat function to op-
erate incorrectly.
●
If this button is pressed during normal op-
eration, the unit will switch to test opera-
tion mode, and the Indoor Unit’s OPERA-
TION Indicator Lamp and TIMER Indicator
Lamp will begin to flash simultaneously.
●
To stop the test operation mode, press the
START/STOP button to stop the air condi-
tioner.
W
CLOCK ADJUST button
X
Remote Control Unit Display (Fig. 7)
Y
Transmit Indicator
Z
Clock Display
[
Operating Mode Display
\
Timer Mode Display
]
Fan Speed Display
`
Temperature SET Display
a
SLEEP Display
b
SWING Display
NAME OF PARTS
●
Refer to the folded out page on the cover.
Fig. 1 Indoor Unit
1
Operating Control Panel (Fig. 2)
2
MANUAL AUTO button
●
When kept on pressing the MANUAL
AUTO button for more than 10 seconds,
the forced cooling operation will start.
●
The forced cooling operation is used at the
time of installation.
Only for authorized service personnel's
use.
●
When the forced cooling operation starts
by any chance, press the START/STOP but-
ton to stop the operation.
3
Indicator (Fig. 3)
4
Remote Control Signal Receiver
5
OPERATION Indicator Lamp (red)
6
TIMER Indicator Lamp (green)
●
If the TIMER indicator lamp flashes when
the timer is operating, it indicates that a
fault has occurred with the timer setting
(See Page 14 Auto Restart).
7
SUPER QUIET Indicator Lamp (orange)
8
Intake Grille (Fig. 4)
9
Front Panel
0
Air Filter
A
Air Flow Direction Louver
B
Power Diffuser
C
Right-Left Louver
(behind Air Flow Direction Louver)
D
Drain Hose
E
Air Cleaning Filter
Fig. 5 Outdoor Unit
F
Intake Port
G
Outlet Port
H
Pipe Unit
I
Drain port (bottom)
