PREPARATION
CAUTION!
●
Take care to prevent infants from
accidentally swallowing batteries.
●
When not using the Remote Control Unit
for an extended period, remove the
batteries to avoid possible leakage and
damage to the unit.
●
If leaking battery fluid comes in contact
with your skin, eyes, or mouth, immedi-
ately wash with copious amounts of
water, and consult your physician.
●
Dead batteries should be removed
immediately and disposed of properly,
either in a battery collection receptacle
or to the appropriate authority.
●
Do not attempt to recharge dry batteries.
Never mix new and used batteries, or
batteries of different types.
Batteries should last about one year
under normal use. If the Remote Con-
trol Unit’s operating range becomes ap-
preciably reduced, replace the batteries
and press the RESET button with the tip
of a ballpoint pen or other small object.
Turn on the Power
1
Connect the Power Supply Plug (Fig. 1
D
) to an electri-
cal outlet; in the case of a direct line connection, turn
on the circuit breaker.
Load Batteries (AAA / R03/LR03
×
2)
1
Press and slide the battery compartment lid on the re-
verse side to open it.
Slide in the direction of the arrow while pressing the
mark.
2
Insert batteries.
Be sure to align the battery polarities (
) correctly.
3
Close the battery compartment lid.
Set the Current time
1
Press the CLOCK ADJUST button (Fig. 6
U
).
Use the tip of a ball-point pen or other small object to press the button.
2
Use the TIMER SET (
/
) buttons (Fig. 6
T
) to
adjust the clock to the current time.
button:
Press to advance the time.
button:
Press to reverse the time.
(Each time the buttons are pressed, the time will be advanced/reversed in
one-minute increments; hold the buttons depressed to change the time
quickly in ten-minute increments.)
3
Press the CLOCK ADJUST button (Fig. 6
U
) again.
This completes the time setting and starts the clock.
To Use the Remote Control Unit
●
The Remote Control Unit must be pointed at signal receiver (Fig. 3
4
) to operate
correctly.
●
Operating Range: About 7 meters.
●
When a signal is properly received by the air conditioner, a beeping sound will
be heard.
●
If no beep is heard, press the Remote Control Unit button again.
Remote Control Unit Holder
3
To remove the Remote
Control Unit (when use at
hand).
1
Mount the Holder.
2
Set the Remote Control
Unit.
Screws
Insert
Press in
Slide up
Pull out
En-5
08H307_9317433068_En
2008.8.29, 13:21
6
