Fig. 6 Remote Control Unit
K
Signal Transmitter
L
MASTER CONTROL button
M
SLEEP button
N
TIMER MODE button
O
FAN CONTROL button
P
START/STOP button
Q
SET TEMP. button (
/
)
R
SET button
S
SWING button
T
TIMER SET (
/
) button
U
CLOCK ADJUST button
V
TEST RUN button
●
This button is used when installing the
conditioner, and should not be used un-
der normal conditions, as it will cause the
air conditioner’s thermostat function to op-
erate incorrectly.
●
If this button is pressed during normal op-
eration, the unit will switch to test opera-
tion mode, and the Indoor Unit’s OPERA-
TION Indicator Lamp and TIMER Indicator
Lamp will begin to flash simultaneously.
●
To stop the test operation mode, press the
START/STOP button to stop the air condi-
tioner.
W
RESET button
X
Remote Control Unit Display (Fig. 7)
Y
Transmit Indicator
Z
Temperature SET Display
[
Fan Speed Display
\
Operating Mode Display
]
SWING Display
`
SLEEP Display
a
Timer Mode Display
b
Clock Display
Fig. 1 Indoor Unit
1
Operating Control Panel (Fig. 2)
2
MANUAL AUTO button
●
When kept on pressing the MANUAL
AUTO button for more than 10 seconds,
the forced cooling operation will start.
●
The forced cooling operation is used at the
time of installation.
Only for authorized service personnel's
use.
●
When the forced cooling operation starts
by any chance, press the START/STOP but-
ton to stop the operation.
3
Indicator (Fig. 3)
4
Remote Control Signal Receiver
5
OPERATION Indicator Lamp (green)
6
TIMER Indicator Lamp (orange)
●
If the TIMER indicator lamp flashes when
the timer is operating, it indicates that a
fault has occurred with the timer setting
(See Page 14 Auto Restart).
7
SUPER QUIET Indicator Lamp (yellow)
8
Intake Grille (Fig. 4)
9
Front Panel
0
Air Filter
A
Air Flow Direction Louver
B
Right-Left Louver
(behind Air Flow Direction Louver)
C
Drain Hose
D
Power Supply Plug
E
Power Supply Cord
F
Air Cleaning Filter
Fig. 5 Outdoor Unit
G
Intake Port
H
Outlet Port
I
Pipe Unit
J
Drain port (bottom)
En-4
08H307_9317433068_En
2008.8.29, 13:21
5
