E
1
1 Installing the Drive
To install and use this product with the mainframe of the teamserver, see the User’s Guide
included with the mainframe. Before installation, setting pins, motor start mode, and SCSI-ID
must be set.
Locations of Setting Pins (GP5-HD9G3/GP5-HD8G1)
Motor start mode
at shipment: off (short)
Terminator power
supply setting
Setting at shipment: on (short)
All open
All open
ID0
ID1
ID2
ID3
Terminator power supply setting
Setting at shipment: ON (Short)
(Bottom view)
(Bottom view)
(Bottom view)
(Over view)
All Open
(Side view)
(Side view)
(Side view)
Pin number: 7
5
6
4 3 2 1
＜HDD printed STxxxxxxLW on the label＞
＜HDD printed MAHxxxxMP on the label＞
＜HDD printed DNES-xxxxxx on the label＞
SCSI ID
at shipment: #15
All open
All open
Motor start mode
at shipment: off (open)
Terminator power supply
setting
Setting at shipment: on (short)
SCSI ID
at shipment: #15
Motor start mode
at shipment: off (open)
ID0
ID1
ID2
ID3
(Side view)
SCSI ID
at shipment: #15
All open
ID0
ID1
ID2
ID3
(Note) The product has no function for setting terminator.
As for GP5-HD9G3C and GP5-HD8G1C, SCSI-ID has been set in “#5” since factory
shipments.
