En-4
Display panel
To facilitate explanation, the accompanying illustration has
been drawn to show all possible indicators; in actual oper-
ation, however, the display will only show those indicators
appropriate to the current operation.
1
MODE button
2
10 °C HEAT button
3
SET TEMP. button (
/
)
4
ECONOMY button
5
SLEEP button
6
FAN button
7
START/STOP button
8
SET button (Vertical)
9
SET button (Horizontal)
0
SWING button
A
TIMER MODE button
B
TIMER SET (
/
) button
C
CLOCK ADJUST button
D
RESET button
E
TEST RUN button
●
This button is used when installing the condi-
tioner, and should not be used under normal
conditions, as it will cause the air conditioner’s
thermostat function to operate incorrectly.
●
If this button is pressed during normal opera-
tion, the unit will switch to test operation mode,
and the Indoor Unit’s OPERATION Indicator
Lamp and TIMER Indicator Lamp will begin to
fl
ash simultaneously.
●
To stop the test operation mode, press the
START/STOP button to stop the air conditioner.
F
Signal Transmitter
G
Temperature SET Display
H
Operating Mode Display
I
SLEEP Display
J
Transmit Indicator
K
Fan Speed Display
L
SWING Display
M
T imer Mode Display
N
Clock Display
Some indoor units may not be equipped with the functions
corresponding to all of the buttons on this remote control-
ler. The indoor unit will beep and the OPERATION, TIMER
and ECONOMY lamp
fl
ash when a remote controller but-
ton is pressed if the function is not available.
Remote controller
Display
9374379446_OM.indb 4
9374379446_OM.indb 4
1/12/2553 14:51:04
1/12/2553 14:51:04
