Fujitsu D1567, Technical Manual

Page: 20 / 47

Internal ports and connectors
10 - English
A26361-D1567-Z121-1-6319
Graphics port - Supported screen resolutions
Depending on the operating system used, the screen resolutions in the following table refer to the
mainboard screen controller.
If you are using an external screen controller, you will find details of supported screen resolutions in
the operating manual or technical manual supplied with the controller.
Screen resolution Refresh rate (Hz) Colour Features
640 x 480 120 32 bit 2D+overlay
800 x 600 120 32 bit 2D+overlay
1024 x 768 100 32 bit 2D+overlay
1280 x 1024 100 32 bit 2D
1600 x 1200 100 16 bit 2D
1920 x 1440 75 16 bit 2D
2048 x 1536 60 16 bit 2D
Internal ports and connectors
The positions of the internal ports and connectors are shown on the Cover. Additional information on
some ports is also provided here.
Hard disk connection
An ultra ATA/66 or ultra ATA/100 hard disk must be connected with a cable especially designed for
the ultra ATA/66 or ultra ATA/100 mode.
► Connect the end of the cable marked with blue to the mainboard.
A serial ATA/150 hard disk must be connected with a serial ATA cable.
► Connect the cable to the hard disk and to the connector on the mainboard.
If you have connected one or two hard disks to a serial ATA (one hard disk is possible per serial
ATA connection), you must configure the respective settings in the
BIOS Setup (further information
you can find in the
BIOS Setup
manual).
Audio front panel
If you want to use the internal connection for the audio front panel for the front side of the system,
then proceed as follows:
► Remove all plug-in jumpers from the audio front panel connection.
► Connect the cable for the audio front panel.
i
If you connect audio devices on both the front and the back of the system, you can only
use the connections Line out and Microphone once each.
If you have connected audio devices to both Line out connections, only the connection on
the front of the system is active.
If you have connected audio devices to both Microphone connections, only the connection
on the back of the system is active.