En-4
Fig. 1 Indoor Unit
1
Operating Control Panel (Fig. 2)
2
MANUAL AUTO button
●
When kept on pressing the MANUAL
AUTO button for more than 10 seconds,
the forced cooling operation will start.
●
The forced cooling operation is used at the
time of installation.
Only for authorized service personnel's
use.
●
When the forced cooling operation starts
by any chance, press the START/STOP but-
ton to stop the operation.
●
Please press the button at FILTER INDICA-
TOR RESET.
3
Indicator (Fig. 3)
4
Remote Control Signal Receiver
5
OPERATION Indicator Lamp (green)
6
TIMER Indicator Lamp (orange)
●
If the TIMER indicator lamp flashes when
the timer is operating, it indicates that a
fault has occurred with the timer setting
(See Page 16 Auto Restart).
7
ECONOMY Indicator Lamp (green)
8
DEFROST Indicator Lamp (green)
9
Intake Grille (Fig. 4)
0
Front Panel
A
Air Filter
B
Airflow Direction Louver
C
Right-Left Louver
(behind Airflow Direction Louver)
D
Drain Hose
E
Air Cleaning Filter
F
Remote Controller (Wired/Option)
NAME OF PARTS
Fig. 5 Remote Controller
G
Signal Transmitter
H
MODE button
I
10°C HEAT button
J
SET TEMP. button (
/
)
K
ECONOMY button
L
SLEEP button
M
TIMER MODE button
N
FAN button
O
START/STOP button
P
SET button
Q
SWING button
R
TIMER SET (
/
) button
S
CLOCK ADJUST button
T
TEST RUN button
●
This button is used when installing the air
conditioner, and should not be used un-
der normal conditions, as it will cause the
indoor unit’s thermostat function to oper-
ate incorrectly.
●
If this button is pressed during normal op-
eration, the indoor unit will switch to test
operation mode, and the Indoor Unit’s OP-
ERATION Indicator Lamp and TIMER
Indicator Lamp will begin to flash simulta-
neously.
●
To stop the test operation mode, press the
START/STOP button to stop the air
conditioner.
U
RESET button
V
Remote Controller Display (Fig. 6)
W
Transmit Indicator
X
Fan Speed Display
Y
SWING Display
Z
Timer Mode Display
[
Clock Display
\
Temperature SET Display
]
Operation Mode Display
^
SLEEP TIMER Display
