Fujitsu AOT25AN, Operating Manual

Page: 12 / 16

11
°
C
NON STOP
CLOCK TEMP
AUTO
TIMER
MODE
SET
ZONE START/STOP
CLOCK ADJUST
SET TIME TEMP./DAY FAN
CONTROL
MASTER
CONTROL
2 1
HIGH
AUTO
COOL
DEFROST TEST
DAY OFF
ENERGY SAVE
ENERGY SAVE OPERATION
To Use the ENERGY SAVE
Press the ENERGY SAVE button.
The unit will run in the ENERGY SAVE mode.
The ENERGY SAVE lamp (green) will light.
To Stop the ENERGY SAVE
Press the ENERGY SAVE button one more time.
The ENERGY SAVE mode will be turned off.
The ENERGY SAVE lamp goes off, and the unit will return to the former operat-
ing conditions.
About the ENERGY SAVE
●
The energy conservation mode (ENERGY SAVE) raises the set temperature slightly in the cooling mode and lowers the set
temperature in the heating mode, using a computer program to economically control the operation of the unit.
●
If you press the ENERGY SAVE button while the air conditioner is on, it will change to the conservation mode. If you press
the ENERGY SAVE button while the unit is in the timer mode (ON timer, WEEKLY timer), the unit will go into the conserva-
tion mode when the unit starts with the timer.
●
If you turn off the air conditioner while in the conservation mode, the mode will be shut off.
●
The temperature set on the remote controller will not change if the energy save mode is used.
■
* When Heating
After the ENERGY SAVE button is pressed, the set tempera-
ture will be lowered about 1 °C every 30 minutes. When it
has lowered a total of 2 °C, then it will hold that tempera-
ture.
■
When Cooling
After the ENERGY SAVE button is pressed, the set tempera-
ture will be raised about 0.5 °C every 30 minutes. When it
has gone up a total of 1 °C, then it will hold that tempera-
ture.
30 min.
0.5 °C
1 °C
▼
Set to the ENERGY SAVE mode.
1 °C
2 °C
30 min.
▲
Set to the ENERGY SAVE mode.
Instructions relating to heating (*) are applicable only to “HEAT & COOL MODEL” (Reverse Cycle).