5
Fig. 1 Indoor Unit
1
Operating Control Panel (Fig. 2)
2
MANUAL AUTO button
3
Indicator (Fig. 3)
4
Remote Control Signal Receiver
5
OPERATION Indicator Lamp (red)
6
TIMER Indicator Lamp (green)
●
If the TIMER indicator lamp flashes when
the timer is operating, it indicates that a
fault has occurred with the timer setting
(See Page 15 Auto Restart).
7
SUPER QUIET Indicator Lamp (green)
8
COIL DRY Indicator Lamp (orange)
9
Intake Grille
0
Open Panel (Fig. 4)
A
Air Filter
B
Air Flow Direction Louver
C
Right-Left Louver
(behind Air Flow Direction Louver)
D
Drain Hose
E
Power Supply Plug
F
Power Supply Cord
G
Air Cleaning Filter (optional)
Fig. 5 Outdoor Unit
H
Intake Port
I
Outlet Port
J
Pipe Unit
K
Drain port (bottom)
Fig. 6 Remote Control Unit
L
SLEEP button
M
MASTER CONTROL button
N
SET TEMP. button (
/
)
O
COIL DRY button
P
Signal Transmitter
Q
OFF TIMER button
R
ON TIMER button
S
SET TIMER button
T
CANCEL TIMER button
U
FAN CONTROL button
V
START/STOP button
W
AIR FLOW DIRECTION button
X
SWING button
Y
ACL button
Z
TEST RUN button
●
This button is used when installing the
conditioner, and should not be used un-
der normal conditions, as it will cause the
air conditioner’s thermostat function to op-
erate incorrectly.
●
If this button is pressed during normal op-
eration, the unit will switch to test opera-
tion mode, and the Indoor Unit’s OPERA-
TION Indicator Lamp and TIMER Indicator
Lamp will begin to flash simultaneously.
●
To stop the test operation mode, press the
START/STOP button to stop the air condi-
tioner.
[
Remote Control Unit Display (Fig. 7)
\
Transmit Indicator
]
Operating Mode Display
`
Timer Mode Display
OFF TIMER Mark:
ON TIMER Mark:
SLEEP TIMER Mark:
a
Fan Speed Display
b
Temperature and time Display
It displays the temperature setting. How-
ever, when making the Timer setting, it will
display the Timer time. (The temperature
setting will reappear after finishing the
timer setting)
c
COIL DRY Display
d
SWING Display
9312556052-En.pm6.5
2003.5.14, 9:17 AM
5
