Fujitsu AOA72LALT, Design & Technical Manual

Page: 67 / 77

- (02 - 26) -
O
U
TD
O
O
R U
N
IT
AO

A
72
-9
0L
A
LT
O
U
TD
O
O
R U
N
IT
AO

A
72
-9
0L
A
LT
SETTING METHOD 14-2-1.
(1) Turn on the power of the outdoor
unit and enter standby mode.
POWER/MODE lamp lights up.
(ERROR Lamp is off.)
(2) Press the MODE/EXIT button (SW107) once.
LED105 LED104 LED105 LED104
(3) Press the SELECT button (SW108), and display “F2” on the LED104.
*1 *1
LED105 LED104 LED105 LED104 LED105 LED104 LED105 LED104
(The display of the LED104 changes each time the SELECT button is pressed.)
(Function mode) (Setting mode)
*1: The “F1” and “F9” modes are used for maintenance, so do not set them in regular operation.
(4) When “F2” appears on the LED104, press the ENTER button (SW109).
LED105 LED104 LED105 LED104
(5) Referring to the Settings List shown below, press the SELECT button (SW108) and display
the code number of the mode you want to set on the LED105.
Ex.) To select the Low noise operation setting.
LED105 LED104 LED105 LED104
Next, press the ENTER button (SW109), and confirm the selection of the mode you want to set.
LED105 LED104 LED105 LED104
A flashing display on the LED105 changes to an illuminated display, and an illuminated display
on the LED104 changes to flashing display.
POWER
LED105 LED104
SW101
ERROR
MODE
LED101
(GREEN)
MODE
/EXIT
PUMP
DOWN
SELECT ENTER
SW107 SW108 SW109 SW102
LED102
(RED)
POWER/MODE Lamp: ON
ERROR Lamp: OFF
7 Segment
LED Lamp: OFF
DIP switch
(Do not operate.)
PUMP DOWN button
(Do not operate in this chapter.)
ENTER button
SELECT button
MODE/EXIT button