- (01 - 30) -
W
AL
L M
OU
NT
ED T
YP
E
AS
G
07
-1
4L
U
W
AL
L M
OU
NT
ED T
YP
E
AS
G
07
-1
4L
U
REMOTE CONTROLLER SIGNAL CODE SETTING
Use the following steps to select the signal code of the remote controller. (Note that
the air conditioner cannot receive a signal code if the air conditioner has not been set
for the signal code.)
Press the START/STOP (
1.
/ ) button until only the clock is displayed on the remote
controller display.
Press the MODE button for at least 5 seconds to display the current signal code
2.
(initially set to ).
Press the SET TEMP. (
3.
/
) buttons to change the signal code between
→ → →
.
Match the code on the display to the air conditioner signal code.
Press the MODE button again to return to the clock display. The signal code will
4.
be changed.
• If no buttons are pressed within 30 seconds after the signal code is displayed, the system returns to the original
clock display. In this case, start again from step 1.
• The air conditioner signal code is set to A prior to shipment.
Summary of Contents for AO*G07LUC
Page 10: ... 01 07 WALL MOUNTED TYPE AS G07 14LU WALL MOUNTED TYPE AS G07 14LU INSTALLATION PLACE Unit mm ...
Page 35: ...2 OUTDOOR UNIT SINGLE TYPE AO G07LUC AO G09LUC AO G12LUC AO G14LUC DTR_AO085E_01 2011 04 08 ...
Page 42: ... 02 06 OUTDOOR UNIT AO G07 14LU OUTDOOR UNIT AO G07 14LU MODEL AO G12LU AO G14LU ...
Page 51: ... 02 15 OUTDOOR UNIT AO G07 14LU OUTDOOR UNIT AO G07 14LU SOUND LEVEL CHECK POINT 88888 ...